[. . . ] To remove the controller, push the controller from the hole located on the back of the Shield. How to Insert the PlayStation Move motion controller into the Archery Bow: 1. NOTE: Before inserting the PlayStation Move motion controller into any extension or accessory, please make sure that you sync the controller to your PlayStation system first. [. . . ] Match the pointed arrows located on both the Remote Cradle and each extension. To release the extension from the Remote Cradle, hold down the latch on the front of the Remote Cradle and turn the extension clockwise and pull off the Remote Cradle. How to Insert the PlayStation Move motion controller into the Shield: NOTE: Make sure that the wrist strap that is included with the PlayStation Move motion controller is being used. Please refer to the PlayStation Move motion controller's User's Guide on how to install the wrist strap onto the controller. Slide the Release Button located on both sides of the Motion Blaster towards the back of the blaster (see Image A1). Line up the directional and Menu buttons with the intended holes on the Archery Bow as shown in Image B. Insert the PlayStation®MOVE motion controller or navigation controller into the elastic holders on each glove. To charge an original PlayStation Move motion or navigation controller, place the controller onto the correct port. Make sure that the bottom of the controller is aligned with the mini-USB plug on the controller plug. The LED charge indicator will turn RED when charging and BLUE when fully charged. NOTE: When the controller or device is about 95% charged, the LED charge indicators will flash between a RED and BLUE LED. NOTE: You can charge up to 2 DualShock3 or SIXAXIS controllers, 1 PlayStation Move motion controller, 1 PlayStation Move navigation controller and 2 other USB devices (with the 2 USB ports) simultaneously. ⷠ2 USB ports are located on the back of the Quad Dock Pro to charge other devices such as a headset or keypad. Please refer to the User's Guide of each device for charging times and charging instructions. ⷠOnce your controller or device is fully charged, make sure that you disconnect the controller or device from the Quad Dock Pro. Plug the USB side of the USB Charging to any USB port on your PS3 (or any powered USB port). [. . . ] Slide the Release Button towards the front of the Motion Blaster to lock. To remove the PlayStation Move motion controller from the Motion Blaster, simply follow steps 1 and 2. Once the steps are completed, hold the controller at the top and pull up. [. . . ]